Electronic Controls Engineer
Boral

Job Info

JOB SUMMARY
Under the direct supervision of the Engineering Services Manager, the Electrical Control Engineer provides technical support to operating regions as well as design engineering, assembly/installation supervision and commissioning in capital projects assigned. (Dotted Line Supervision with Plant Manager of Facility)

ESSENTIAL FUNCTIONS:

• Comply with Boral Safety Policies and Procedures
• Provide technical support in all electrical / electronic / process control aspects to operating regions and report results to the Engineering Services Manager
• Design, commission and provide training concerning electrical control projects as assigned. This is inclusive of electrical loading calculations, panel layouts, boms, schematics, flow charts, cabling sheets and software documentation.
• During job project progression, supervise electrical panel assembly shops, electrical contractors and plant electrical personnel
• Recommend needed circuitry modifications to insure not only increased production efficiency, but also increased production personnel safety
• Liaise with regional plant technicians, through regional plant management, to insure an open communication channel of uninterrupted feedback request for technical support
• Insure proper documentation of all projects, modifications and revisions concerning both hardware and software control aspects within the regional production facilities

KNOWLEDGE, SKILLS AND ABILITIES

• Must possess strong communication and handwriting skills at an engineering level- should be able to clearly and precisely explain and document any hardware/software projects as well as problems and solutions.
• Computer literate - strong knowledge of computers required, including Microsoft Windows based operating systems, Microsoft Office and Microsoft Project.
• Remain current with PLC equipment, software, and practices by attending courses at approved PLC manufacturers training centers.
• Lay out/ construct additional electrical circuits or deleted circuits. Update any changes to electrical schematics.
• Troubleshoot, repair and adjust PLC electrical systems.
• Diagnose electrical problems using various meters and related equipment.
• Read and understand electrical schematics and blueprints.
• Working knowledge of single phase, three phase motor systems and control circuits.
• Ability to apply ANSI, IEC and NEMA standards design within the electrical industry.
• Knowledgeable of OSHA safety requirements. (29 CFR 1910)
• Strong knowledge of National Electrical Code. (NFPA 70) and Standard for Electrical Safety in the Workplace (NFPA 70E)